How to install paint protection film – calgary ppf 3m calgary
Paint protection film, also known as PPF, is a clear film that is applied to the exterior of your vehicle to protect it from scratches, rock chips, and other types of damage. It’s a great investment for those who want to keep their car looking brand new for years to come. Installing PPF is not as difficult as it may seem, but it does require some patience and attention to detail. In this blog, we’ll guide you through the steps on how to install paint protection film on your car.
Materials you’ll need:
- Paint protection film
- Squeegee
- Spray bottle
- Soap and water mixture
- Razor blade
- Heat gun
Step 1: Clean the car
Before you begin the installation process, it’s essential to clean your vehicle thoroughly. Use soap and water to remove any dirt, grime, and debris from the surface of your car. Dry it completely before proceeding to the next step.
Step 2: Measure and cut the PPF
Measure the area of your vehicle that you want to cover with PPF. It’s crucial to measure accurately, so you don’t waste any film or end up with gaps that could allow debris to get underneath. When cutting the PPF, leave a little extra material around the edges to allow for trimming later..
Step 3: Apply the PPF
Spray the soap and water mixture on the surface of your car where you’ll be applying the PPF. Then, carefully lay the film on top of the wet surface. The soap and water mixture will allow you to slide the film into the correct position before it dries.
Using a squeegee, press the film firmly onto the surface of your car, starting from the center and working your way outward. Be sure to work out any air bubbles as you go. Use the heat gun to help stretch the Calgary paint protection film around curves and corners.
Step 4: Trim the edges
After applying the film to the surface of your car, use a razor blade to trim off the excess material around the edges. Be careful not to scratch the surface of your car when cutting.
Step 5: Heat the edges
To ensure that the PPF adheres properly, use a heat gun to heat up the edges of the film. This will activate the adhesive and help the film stick to the surface of your car.
Step 6: Clean up
Once you’ve finished applying the PPF, clean up any excess soap and water from the surface of your car. Use a microfiber cloth to dry the area thoroughly.
Tips for a successful installation:
- Make sure the surface of your car is clean and dry before applying the PPF.
- Use a squeegee to work out any air bubbles as you apply the film.
- Use a heat gun to help stretch the film around curves and corners.
- Trim the edges carefully with a razor blade to avoid scratching the surface of your car.
- Heat up the edges of the film to activate the adhesive and ensure proper adhesion.
- Take your time and be patient. Rushing the Calgary PPF installation process could lead to mistakes.
Benefits of using PPF:
- Protection against scratches and rock chips
- Helps maintain the resale value of your car
- Easy to clean and maintain
- Keeps your car looking new for years to come
Conclusion:
The paint protection film is an excellent investment in the Calgary car detailing services for those who want to keep their car looking new for years to come. While the installation process requires some patience and attention to detail, it’s not as difficult as it may seem. By following the steps outlined in this blog and with the help of professionals from Drip Detailing, you can successfully install PPF on your vehicle and enjoy the benefits of added protection against scratches and rock chips. Remember to take your time and be patient, and you’ll have a beautifully protected car in no time
